IC BUS BE

SEAT BELTS

Navistar, Inc. (Navistar) is recalling certain 2011 IC Bus BE, CE, and RE school buses equipped with certain non-retractable passenger two-point seat belts. After long term buckling and unbuckling of the seat belt, the plastic fingers on the male portion of the buckle may crack and fall off, requiring excessive force to buckle the seat belt.

Risk: The seat belt may not easily buckle, increasing the risk of an injury in the event of a crash.

EQUIPMENT ADAPTIVE/MOBILITY

Navistar, Inc. (Navistar) is recalling certain model year 2015 IC Bus AE and BE, 2015-2017 CE and 2016-2017 RE school buses, equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts by Ricon. The affected lifts are equipped with folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position.

Risk: If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting. This failure could cause the wheel chair lift platform to fall out of the vehicle when the doors are opened, increasing the risk of injury for the lift operator.

ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS

Navistar, Inc. (Navistar) is recalling certain model year 2011-2016 IC Bus CE school buses manufactured November 3, 2009, to February 26, 2015, and 2012-2015 IC Bus BE school buses manufactured August 2, 2010, to September 15, 2014. The affected vehicles have a water shutoff valve, inside, forward of driver heater (feature code 48PPJ or 48PPP) that has a formed heater hose that over time, may fatigue and split resulting in hot engine coolant fluid leaking into the driver's foot area.

Risk: If hot, pressurized coolant suddenly spills into the operator's foot area, there is an increased risk of a burn injury or a crash.

ENGINE AND ENGINE COOLING:COOLING SYSTEM:HOSES/LINES/PIPING/FITTINGS

Navistar, Inc. (Navistar) is recalling certain model year 2011-2016 IC Bus CE transit buses manufactured July 1, 2010, to February 4, 2015, and one IC Bus BE transit bus manufactured on November 2, 2010. The affected vehicles have a water shutoff valve, inside, forward of driver heater (feature code 48PPJ or 48PPP) that has a formed heater hose that over time, may fatigue and split resulting in hot engine coolant fluid leaking into the driver's foot area.

Risk: If hot, pressurized coolant suddenly spills into the operator's foot area, there is an increased risk of a burn injury or a crash.

EQUIPMENT ADAPTIVE/MOBILITY

Navistar, Inc. is recalling certain model year 2007-2015 IC BE and CE school buses, 2013-2015 IC AE school buses, 2007-2011 IC FE school buses, and 2007-2014 IC RE school buses equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts by Ricon. The affected lifts are equipped with folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position.

Risk: If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting. This failure could cause the wheel chair lift platform to fall out of the vehicle when the doors are opened, increasing the risk of injury for the lift operator.

EQUIPMENT ADAPTIVE/MOBILITY

Navistar, Inc. (Navistar) is recalling certain model year 2013-2015 IC AE, 2007-2015 IC BE, CE, 2007-2011 IC FE, and 2007-2014 IC RE school buses equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts manufactured by Ricon Corporation after January 1, 2006. The platform side plate of the affected wheelchair lifts may crack.

Risk: If the platform side plates crack, the lift platform can separate from the lift and come to rest against the vehicle's lift door. When the doors are opened, the platform may fall out, increasing the risk of injury to the lift operator.

SEATS

Navistar, Inc. is recalling certain model year 2013-2014 IC Bus AE, and 2011-2014 BE, CE, and RE buses. These buses were manufactured February 11, 2010, through June 17, 2013. The passenger seat foam padding did not adequately reduce the impact forces to the knee in the lower outside corners of the seat back during compliance testing. Thus, these buses fail to conform to the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 222, "School Bus Passenger Seating and Crash Protection."

Risk: In the event of a crash, the seat padding may not properly protect against knee impact force, increasing the risk of injury.

SEAT BELTS

Navistar, Inc. is recalling certain model year 2014 IC Bus AE, BE and RE and model year 2014-2015 IC Bus CE school buses manufactured August 08, 2013, through November 14, 2013 and equipped with IMMI-brand L9 seat belt buckles. When the button is pressed to release the seat belt, the latch plate can become partially engaged with the buckle, making the seat belt difficult to unlatch. Thus, these vehicles fail to conform to the requirements of Federal Motor Vehicle Safety Standard (FMVSS) No. 209, "Seat Belt Assemblies."

Risk: If the latch plate remains partially engaged after the button is pressed, egress from the vehicle could be hindered which would increase the risk of injury in the event of an emergency.

SEATS

NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2011-2012 IC BUS BE AND CE AND CERTAIN MODEL YEAR 2012 RE SCHOOL BUSES MANUFACTURED FROM APRIL 8, 2010 THROUGH JULY 1, 2011, EQUIPPED WITH C. E. WHITE SEAT CUSHIONS. THE SELF-LATCHING MECHANISM USED TO RETAIN THE SEAT CUSHION TO THE FRAME MAY NOT ACTIVATE. THUS, THESE SEATS FAIL TO CONFORM TO THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 222, "SCHOOL BUS PASSENGER SEATING AND CRASH PROTECTION."

Risk: IF THE SEAT CUSHION IS NOT SECURELY LATCHED TO THE SEAT STRUCTURE, THE SEAT COULD BECOME DISLODGED, INCREASING THE RISK OF INJURY TO THE VEHICLE OCCUPANTS.