📧 info@texaslemonlaw.com 📞 +1 866 777 5045
Free Consultation Available

2012 SPARTAN K2

View all complaints and recalls for this specific model year.

2012 SPARTAN K2 Summary

2012

Model Year

0

Total Complaints

8

Total Recalls

4265

Vehicles Affected

Recalls

2012 SPARTAN K2

2783 vehicles affected

17V160000

SUSPENSION:FRONT:CONTROL ARM

Spartan Motors USA (Spartan) is recalling certain 2011-2017 Gladiator, 2016-2017 MetroStar, 2012-2018 K2, 2011-2018 K3, 2017-2018 K4, and 2011-2017 MM vehicles. The ball joints on the independent front suspension (IFS) modules can loosen and separate, leading to a partial loss of steering.

Risk: A separated ball joint can cause a loss of steering control, increasing the risk of a crash.

2012 SPARTAN K2

721 vehicles affected

17V351000

ELECTRICAL SYSTEM:STARTER ASSEMBLY

Spartan Motors USA (Spartan) is recalling certain 2010-2014 K2 and K3 motor home chassis and Gladiator emergency response chassis cabs. A component within the starter motor may break, potentially resulting in the starter motor overheating or drawing excessive current.

Risk: A starter motor that overheats may increase the risk of a fire.

2012 SPARTAN K2

75 vehicles affected

13V242000

SUSPENSION:FRONT:WHEEL BEARING

Spartan Motors, Inc. (Spartan) is recalling certain model year 2012-2013 K2, K3, and MM motor homes manufactured March 2, 2012, through July 30, 2012 and equipped with a 1660 independent front suspension supplied by Reyco Granning. The motor homes may have incorrect wheel bearings installed in the front suspension.

Risk: Incorrect wheel bearings may cause the vehicle to pull to one side and with continued use, there is a risk of a fire starting at the wheel.

2012 SPARTAN K2

113 vehicles affected

13V392000

SERVICE BRAKES, AIR:ANTILOCK

Spartan Motor Chassis, Inc. (Spartan) is recalling certain model year 2009-2012 MM, 2011-2014 K2, and 2010-2012 K3 motor home chassis. Due to contact with the steering relay rod, the ABS modulator valve may fracture resulting in air not being applied to the affected wheel end.

Risk: This may increase stopping distance of the vehicle or cause the vehicle to pull to one side. Either condition increases the risk of a crash.

2012 SPARTAN K2

13 vehicles affected

12V125000

SERVICE BRAKES, AIR

SPARTAN IS RECALLING CERTAIN MODEL YEAR 2012 K2 AND MG CHASSIS MANUFACTURED FROM DECEMBER 15, 2011, THROUGH JANUARY 31, 2012, AND EQUIPPED WITH 3030 BRAKE CHAMBERS. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 121, “AIR BRAKE SYSTEMS” BECAUSE THEY DO NOT MEET THE PARK BRAKE AND DRAW BAR REQUIREMENTS.

Risk: THE PARK BRAKE MAY NOT HOLD THE VEHICLE IN PLACE AND IF THE VEHICLE MOVES, INJURY OR PROPERTY DAMAGE COULD OCCUR WITHOUT WARNING.

2012 SPARTAN K2

212 vehicles affected

11V425000

ENGINE AND ENGINE COOLING

SPARTAN IS RECALLING CERTAIN MODEL YEAR 2010, 2011, AND 2012 RECREATIONAL VEHICLES, MODELS MM, K2, K3, BUS, FURION, GLADIATOR, AND METRO STAR, MANUFACTURED FROM SEPTEMBER 29, 2010, THROUGH JUNE 20, 2011, EQUIPPED WITH A CUMMINS ISB, ISC, ISL, OR ISX DIESEL ENGINE. THE V-BAND CLAMP ASSEMBLY, PART NUMBERS Q187684, Q187685, AND Q187686, USED TO CONNECT THE INLET AND OUTLET CONE SECTIONS TO THE DIESEL OXIDATION CATALYST (DOC)/DIESEL PARTICULATE FILTER (DPF) INCLUDE A T-BOLT WHICH CAN FRACTURE AND FAIL WHEN SUBJECTED TO STRESS OR LOAD. A FRACTURE OR FAILURE OF THE T-BOLT MAY CAUSE THE CLAMP TO LOOSEN AND THE INLET OR OUTLET SECTIONS ATTACHED TO THE DOC/DPF HOUSING TO DISCONNECT.

Risk: IF THE INLET OR OUTLET SECTIONS DISCONNECT, HOT EXHAUST GASES CAN VENT PRIOR TO EXITING THE TAILPIPE, CREATING THE RISK OF COMBUSTION AND A FIRE. IF BOTH CLAMPS FAIL, THERE IS A RISK IN SOME APPLICATIONS THAT THE DOC/DPF HOUSING MAY DETACH COMPLETELY, CREATING A ROAD HAZARD.

2012 SPARTAN K2

313 vehicles affected

11V412000

SERVICE BRAKES, AIR

Spartan Motors Chassis, Inc. (Spartan Chassis) is recalling certain 2011 SU and 2011 through 2012 model year MM, K2, and K3 recreational vehicle chassis manufactured from January 28, 2011, through June 28, 2011, equipped with air gauges supplied by Ametek. An incorrect value may have been used in the formula for calculating the sweep angle of the dial. This may have resulted in the accuracy of the gauge varying as much as eleven percent from the cutout pressure as opposed to the maximum allowable of +/- seven percent. Consequently, these chassis fail to conform to the requirements of Federal Motor Vehicle Safety Standard No. 121, "Air Brake Systems."

Risk: In a condition where constant braking may be necessary, the air systems may deplete sooner than expected. This could cause the application of the spring brake without warning and may result in a vehicle crash.

2012 SPARTAN K2

35 vehicles affected

11V587000

SERVICE BRAKES, AIR

SPARTAN IS RECALLING CERTAIN MODEL YEAR 2011-2012 K2 RECREATIONAL VEHICLES MANUFACTURED FROM SEPTEMBER 30, 2010, THROUGH NOVEMBER 22, 2011, RATED AT 52,000 LBS AND EQUIPPED WITH 3030 BRAKE CHAMBERS. THESE VEHICLES FAIL TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 121, “AIR BRAKE SYSTEMS” BECAUSE THEY DO NOT MEET THE PARK BRAKE AND DRAW BAR REQUIREMENTS.

Risk: THE PARK BRAKE MAY NOT HOLD THE VEHICLE IN PLACE AND IF THE VEHICLE MOVES, INJURY OR PROPERTY DAMAGE COULD OCCUR WITHOUT WARNING.

Complaints

No complaints found.