2008 MCI D4505
View all complaints and recalls for this specific model year.
2008 MCI D4505 Summary
2008
Model Year
0
Total Complaints
4
Total Recalls
12552
Vehicles Affected
Recalls
2008 MCI D4505
325 vehicles affected
POWER TRAIN:DRIVELINE:DRIVESHAFT
Motor Coach Industries (MCI) is recalling certain model year 1993-1995 102DL3 motor coaches manufactured November 1992 to January 1995, and 2006 and 2008 D4505 motor coaches manufactured June 2005 to April 2008. The affected buses are equipped with a driveshaft with a compressed length of 30 inches or less, a steerable trailing axle equipped with a system that changes the tag axle caster when the vehicle is in reverse travel and no electronic stability control (ESC). In these vehicles, the driveshaft may detach from the transmission and escape its containment bracket.
Risk: If the driveshaft escapes containment it can strike the trailing axle tie rod and components of the trailing axle locking system potentially causing the trailing axle steering and caster locking mechanisms to unlock. If this occurs, the driver may experience loss of steering control of the vehicle, increasing the risk of a vehicle crash.
2008 MCI D4505
10016 vehicles affected
ELECTRICAL SYSTEM
Motor Coach Industries (MCI) is recalling certain model year 2000-2012 D, E, G and J series coaches manufactured January 2000 through June 2011 and equipped with Sure Power battery equalizers containing a particular epoxy sealing, aka 'potting', compound. The specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heat.
Risk: Once electrically conductive, the material is capable of melting and burning, increasing the risk of a fire.
2008 MCI D4505
1962 vehicles affected
ELECTRONIC STABILITY CONTROL (ESC)
MOTOR COACH INDUSTRIES (MCI) IS RECALLING CERTAIN MODEL YEAR 2003, AND 2007-2012 E AND J MODELS ALONG WITH MODEL YEAR 2007-2012 D4000, D4005, D4500, D4505, D4000ISTV MOTOR COACHES EQUIPPED WITH MERITOR WABCO ELECTRONIC STABILITY CONTROL (ESC) MODULES, MANUFACTURED FROM OCTOBER 2002, THROUGH OCTOBER 2011. UNDER CERTAIN ROAD AND DRIVING CONDITIONS, VEHICLE BODY ROLL AND ROAD INCLINATION CHARACTERISTICS MAY ADVERSELY AFFECT THE SLIP ANGLE CALCULATION OF THE ELECTRONIC STABILITY CONTROL (ESC) SYSTEM. THIS MIGHT CAUSE THE ESC TO PERCEIVE AN OVER STEERING SITUATION AND THEREFORE APPLY THE OUTER WHEEL BRAKE ON THE FRONT AXLE UNTIL THE VEHICLE IS PERCEIVED TO BE STABLE.
Risk: IF THE DRIVER IS SLOW TO REACT DURING THIS ESC INTERVENTION, THE VEHICLE MAY DEVIATE FROM THE INTENDED LINE OF TRAVEL, INCREASING THE RISK OF A CRASH.
2008 MCI D4505
249 vehicles affected
EQUIPMENT ADAPTIVE/MOBILITY
MCI HAS NOTIFIED NHTSA OF A DEFECT IN CERTAIN MODEL YEAR 2009 D4000 AND MODEL YEAR 2008-2010 D4500 AND D4505 MOTOR COACHES FITTED WITH RICON PUBLIC USE LIFTS. THE RESTRAINT BELT ON THESE LIFTS WAS DESIGNED TO PREVENT THE LIFT FROM MOVING, UNLESS THE TONGUE OF THE BELT IS FULLY ENGAGED AND LATCHED IN THE BUCKLE. RICON HAS DISCOVERED, HOWEVER, THAT IT IS POSSIBLE FOR THE OPERATOR TO INSERT THE BELT TONGUE INTO THE BUCKLE WITHOUT FULLY ENGAGING THE LATCHING MECHANISM. IN THIS CASE, THE RESTRAINT BELT WOULD APPEAR TO BE LATCHED, AND THE OPERATOR COULD RUN THE LIFT. IF THE RESTRAINT BELT TONGUE IS NOT FULLY ENGAGED INTO THE RESTRAINT BELT BUCKLE, AND LATCHED, THE LIFT MAY OPERATE WITH AN OCCUPANT ON THE PLATFORM.
Risk: THE USER OF THE LIFT COULD BE INJURED SHOULD THE LIFT MOVE WITHOUT THE RESTRAINT BELT PROPERLY BUCKLED.
Complaints
No complaints found.