2010 MAZDA MAZDA3

SEATS

Mazda North American Operations (Mazda) is recalling certain 2011 Mazda2 and 2010-2011 Mazda3 and Mazdaspeed3 vehicles equipped with a manual seat lifter. In the affected vehicles, the seat height adjustment lifter links may break or detach from the seat frame and the seat angle may incline causing the driver to not be able to maintain an appropriate driving position.

Risk: If the driver cannot maintain an appropriate driving position, there is an increased risk of a crash.

UNKNOWN OR OTHER

I have reason to believe the dealership I bought my vehicle from rolled back my odometer. Upon checking my carfax information, 12/01/24, the odometer read 161,142, which the dealership did own my vehicle at this time. When I bought this car in April of 2025, the odometer was reading 130,000.

SERVICE BRAKES

On August 15, 2025, my 2010 Mazda 3 began displaying the ABS warning light intermittently while driving. The ABS system is a critical safety feature, and when the light comes on, I am unsure if the braking system will function properly in an emergency. I scanned the vehicle using a Foxwell diagnostic tool and retrieved the following ABS-related fault codes: C0020:1C-2B – ABS Pump Motor Control Circuit U0425:62-60 – Invalid Data Received from IPC/ABS Control Module U0140:00-28 – Lost Communication with Body Control Module These issues are consistent with Mazda Technical Service Bulletin 04-002/13 (July 17, 2013), which documents ABS pump motor failures caused by poor motor brush contact. This is a serious safety concern because the ABS system fails without warning, leaving the driver and passengers at risk of brake loss in critical conditions. Why this should be investigated: The defect occurs intermittently, making it difficult to predict or reproduce. It matches a known documented defect acknowledged by Mazda in TSB 04-002/13. Other owners have reported similar ABS pump failures in Mazda vehicles of this generation. The failure compromises safe braking and should be treated as a safety defect warranting investigation and possible recall. Action Requested: I am requesting that NHTSA investigate this recurring ABS pump/motor failure in 2010 Mazda 3 vehicles and determine whether a recall should be issued to address this known defect.

ELECTRICAL SYSTEM

The a.b.s pump module is defective in these vehicles. There are tons of people having issues with them. When they fail it happens suddenly resulting in brake failure, power steering failure, the car does not like to shut off, the vehicle will go into "limp mode" and every light on the dash comes on. The part itself is costing close to $1000 u.s.d . With all of tge effected things tgat go with it i believe it can be very dangerous and should be recalled

SERVICE BRAKES

The a.b.s pump module is defective in these vehicles. There are tons of people having issues with them. When they fail it happens suddenly resulting in brake failure, power steering failure, the car does not like to shut off, the vehicle will go into "limp mode" and every light on the dash comes on. The part itself is costing close to $1000 u.s.d . With all of tge effected things tgat go with it i believe it can be very dangerous and should be recalled

SEATS

This vehicle is subject to recall #: 17V-082 referring to a drivers seat lifter link than can break. My car has a broken lifter link, was brought to the dealership and instead of replacing the entire seat adjuster unit like the recall states, they simply installed a reinforcement bracket. When brought back to Med Center Mazda they state it has already been repaired and therefore cannot be repaired again. The vehicle still has a broken seat lifter link.

UNKNOWN OR OTHER

Transmission slipping. Not shifting correctly.