2012 MACK MRU
View all complaints and recalls for this specific model year.
2012 MACK MRU Summary
2012
Model Year
0
Total Complaints
9
Total Recalls
56730
Vehicles Affected
Recalls
2012 MACK MRU
142 vehicles affected
SERVICE BRAKES, AIR:ANTILOCK
Mack Trucks, Inc. (Mack) is recalling certain 2010-2018 MRU and 2019-2025 Terrapro towing vehicles. The vehicles are missing the anti-lock brake (ABS) warning light and circuitry that controls the anti-lock brake function for an attached trailer. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 121, "Air Brake Systems."
Risk: Driving without a functioning anti-lock brake system may result in the trailer not braking as intended, increasing the risk of a crash.
2012 MACK MRU
2124 vehicles affected
ENGINE AND ENGINE COOLING:ENGINE
Mack Trucks, Inc. (Mack) is recalling certain model year 2011-2016 Mack MRU and LEU trucks manufactured June 25, 2010, to April 30, 2015, and 2015-2016 LR6 trucks manufactured from December 18, 2014 through March 6, 2015. Excessive engine crankcase pressures may cause the 90-degree elbow of the vent tube assembly to detach from the crankcase ventilation breather, possibly allowing engine oil to come into contact with hot surfaces.
Risk: If engine oil comes into contact with a hot surface, there could be an increased risk of a fire.
2012 MACK MRU
44047 vehicles affected
EXTERIOR LIGHTING:TURN SIGNAL:FLASHER UNIT
Mack Trucks Inc. (Mack) is recalling certain model year 2010-2014 CHU, CXU, and MRU, 2007 CT and CV, 2008-2014 GU, and 2011-2014 LEU, and TD trucks manufactured February 28, 2006, through November 8, 2013, and equipped Hamsar Electronic Flasher. The hazard warning lights may fail.
Risk: A failure of the hazard warning lights could reduce the trucks visibility, increasing the risk of a crash.
2012 MACK MRU
1934 vehicles affected
ENGINE AND ENGINE COOLING:ENGINE
Mack Trucks Inc. (Mack) is recalling certain model year 2014-2015 CXU, 2010-2015 LEU, and 2011-2015 MRU vehicles manufactured with certain Cummins Westport Model ISL G and ISX12 G engines. Condensation in the intake manifold may freeze during cold weather conditions and interfere with the proper operation of the intake manifold pressure sensor.
Risk: The improper operation of the sensor could induce elevated exhaust temperatures or flames from the exhaust pipe, increasing the risk of a vehicle fire or burn injury to a person near the exhaust pipe.
2012 MACK MRU
318 vehicles affected
ELECTRICAL SYSTEM:ALTERNATOR/GENERATOR/REGULATOR
MACK IS RECALLING CERTAIN MODEL YEAR 2010-2012 LEU AND MODEL YEAR 2011-2012 MRU VEHICLES, MANUFACTURED FROM MAY 14, 2009, THROUGH OCTOBER 31, 2011, AND BUILT TO OPERATE ON COMPRESSED NATURAL GAS. ON THESE VEHICLES THE ALTERNATOR GROUND CABLE RUNS DIRECTLY TO THE STARTER, WHICH DEFEATS THE CIRCUIT PROTECTION.
Risk: IN THE EVENT OF AN ELECTRICAL SHORT, A VEHICLE FIRE MAY RESULT.
2012 MACK MRU
3763 vehicles affected
ELECTRICAL SYSTEM
MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2008-2012 MRU AND LEU HEAVY TRUCKS MANUFACTURED FROM JANUARY 3, 2007, THROUGH FEBRUARY 3, 2011. THE ELECTRICAL CIRCUITRY IN THESE VEHICLES MAY NOT PROVIDE ADEQUATE OVERCURRENT PROTECTION.
Risk: IN THE EVENT OF AN ELECTRICAL OVERAGE, THE FUSE THAT SHOULD PREVENT THE OVER CURRENT FROM REACHING THE MIRROR SWITCH CIRCUIT MAY FAIL, SUCH THAT THE MIRROR SWITCH CAN OVERHEAT. AN OVERHEATED SWITCH COULD CAUSE A VEHICLE FIRE.
2012 MACK MRU
2294 vehicles affected
STEERING:GEAR BOX:SHAFT SECTOR
MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2009-2012 MRU HEAVY TRUCKS MANUFACTURED FROM NOVEMBER 26, 2008, THROUGH APRIL 26, 2011. THE BOLTS USED TO MOUNT THE STEERING GEAR WERE NOT TIGHTENED TO SPECIFICATION. THE BOLTS CAN LOOSEN WHICH OVER TIME MAY CAUSE THE STEERING GEAR TO DISCONNECT FROM ITS MOUNTING BRACKET.
Risk: A COMPLETE LOSS OF STEERING MAY OCCUR INCREASING THE RISK OF A VEHICLE CRASH.
2012 MACK MRU
584 vehicles affected
POWER TRAIN:DRIVELINE
MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2012, CHU, CXU, GU, MRU, LEU, AND TD TRUCKS EQUIPPED WITH A MERITOR DRIVELINE. THE TUBING USED TO ASSEMBLE THE AFFECTED DRIVELINES HAS A NONCONFORMING SEAM WELD WITH INSUFFICIENT BONDING OF THE MATERIAL.
Risk: THIS CAN RESULT IN SEAM WELD FRACTURE WHEN TORQUE IS APPLIED. ONCE THE TUBE SEAM WELD IS FRACTURED, THE DRIVELINE MAY BECOME INOPERABLE WHICH MAY RESULT IN A DISABLED VEHICLE OR DEBRIS FROM THE DRIVELINE MAY FALL ON THE ROADWAY, BOTH OF WHICH CAN INCREASE THE RISK OF A CRASH.
2012 MACK MRU
1524 vehicles affected
SERVICE BRAKES, AIR:SLACK ADJUSTERS:AUTOMATIC
MACK TRUCKS IS RECALLING CERTAIN MODEL YEAR 2011-2012 CHU, CXU, GU, LEU AND MRU TRUCKS MANUFACTURED FROM OCTOBER 15, 2010, THROUGH JANUARY 31, 2011, AND EQUIPPED WITH GUNITE AUTOMATIC SLACK ADJUSTERS. DUE TO AN INCOMPLETE "KNITTING" OF THE IRON AT THE TIME OF CASTING, INADEQUATE STRUCTURAL INTEGRITY OF THE SLACK ADJUSTER HOUSING CAN OCCUR, WHICH COULD CAUSE THE HOUSING TO BREAK AT THE HANDLE UNDER NORMAL OPERATING LOADS.
Risk: SLACK ADJUSTERS WITH THIS FLOW NOTCH COULD CRACK UNDER NORMAL BRAKING CONDITIONS CAUSING LOSS OF BRAKING WHICH COULD RESULT IN A VEHICLE CRASH.
Complaints
No complaints found.