KENWORTH T480
View complaints and recalls by year, or see all recent reports below.
KENWORTH T480 Summary
7
Model Years
0
Total Complaints
46
Total Recalls
2020 - 2026
Year Range
Select Year
Recent Recalls
2026 KENWORTH T480
56260 vehicles affected
EXTERIOR LIGHTING:LIGHTING CONTROL MODULE:SOFTWARE
PACCAR Incorporated (PACCAR) is recalling certain 2024-2026 Kenworth T480, T680, T880, W990, Peterbilt 520, 536, 537, 548, 567, 579, 589, 2025 Kenworth T180, Peterbilt 535, 2025-2026 Kenworth T280, T380 and L770 vehicles. The tail brake light, upper and lower beam headlights, reverse light, and turn signal may not illuminate as intended. In addition, the lift axles, if lowered, may revert to a raised position, or oscillate up and down when the signal warning lights are activated. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) number 108, "Lamps, Reflective Devices and Associated Equipment."
Risk: Delayed and unsteady headlights can result in insufficient illumination of the road, decreasing the driver's visibility and increasing the risk of a crash. In addition, an unexpected position change of the lift axles may increase the risk of injury.
2026 KENWORTH T480
5378 vehicles affected
EXTERIOR LIGHTING:HAZARD FLASHING WARNING LIGHTS:SWITCH
PACCAR Incorporated (PACCAR) is recalling certain 2025 Kenworth T180, Peterbilt 535, 567, 2025-2026 Kenworth T280, 2023-2026 Kenworth T380, 2024-2026 Kenworth T480, 2024-2026 Peterbilt 536, 537, and 548 trucks. The exterior lighting switch may fail, resulting in the hazard lights and the instrument display back-light brightness adjustment not functioning. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) numbers 101, "Control and Displays" and 108, "Lamps, Reflective Devices and Associated Equipment."
Risk: Inoperative hazard lights cannot alert other drivers as intended. In addition, the inability to adjust the brightness on the instrument panel display can make it difficult to see critical safety information or distract the driver. Both scenarios can increase the risk of a crash.
2024 KENWORTH T480
1110 vehicles affected
VEHICLE SPEED CONTROL:ACCELERATOR PEDAL
PACCAR Incorporated (PACCAR) is recalling certain 2023-2024 Peterbilt 535, 536, 537, 548, 2023-2024 Kenworth T280, T380, T480, and 2024 Kenworth T180 trucks. The throttle pedal assembly may contain an oversized magnet carrier, slowing the responsiveness or causing the pedal to stick.
Risk: A pedal that sticks increases the risk of a crash.
2025 KENWORTH T480
782 vehicles affected
STEERING:GEAR BOX:SHAFT SECTOR
PACCAR Incorporated (PACCAR) is recalling certain 2025 Peterbilt 536, 548, 567, 579, and Kenworth T280, T380, T480, T680, T880, and W990 vehicles. The steering gear sector shaft may have been improperly heat-treated, which can cause the gear teeth to crack or fracture.
Risk: Fractured steering gear teeth can cause a loss of steering control, increasing the risk of a crash.
2025 KENWORTH T480
7410 vehicles affected
STEERING:LINKAGES:DRAG:LINK:CONNECTION
PACCAR Incorporated (PACCAR) is recalling certain 2025 Kenworth K270, K370, L770, T280, T380, T480, T680, T880, W900, W990, 2025 Peterbilt 220, 520, 536, 537, 548, 567, 579, and 589 trucks. The tie rod or drag link assembly may contain an improperly heat-treated ball stud, causing the ball stud to break.
Risk: A broken ball stud can cause a complete loss of steering control, increasing the risk of a crash.
2025 KENWORTH T480
220764 vehicles affected
SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:CONTROL UNIT/MODULE
PACCAR Incorporated (PACCAR) is recalling certain 2021-2025 Peterbilt and Kenworth vehicles, equipped with Bendix EC80 Advanced Electronic Control Units (ECU). Please see the recall report for a complete list of models. Electrical noise and low signal to the power line carrier may cause the ECU to incorrectly process commands or stop functioning.
Risk: Safety systems that depend on the ECU (Automatic Traction Control, ABS, Electronic Stability Control, Active Cruise Control, and Collison Mitigation System) may not function properly or at all, increasing the risk of a crash.
2025 KENWORTH T480
70509 vehicles affected
POWER TRAIN:AUTOMATIC TRANSMISSION:LEVER AND LINKAGE:COLUMN SHIFT
PACCAR Incorporated (PACCAR) is recalling certain 2021-2024 Peterbilt 365, 367, 389, 535, 536, 537, 548, 567, 579, and 2021-2025 Kenworth T180, T280, T380, T480, T680, T880 and W990 trucks. The right-hand gear shifter stalk connectors may have been improperly crimped, resulting in a loss of communication.
Risk: A loss of communication between the gear shifter and the transmission may result in the vehicle becoming disabled after coming to a stop, increasing the risk of a crash.
2023 KENWORTH T480
996 vehicles affected
SERVICE BRAKES, AIR:SUPPLY:RESERVOIR/TANK
PACCAR Incorporated (PACCAR) is recalling certain 2009-2021 Kenworth C500, 2012-2021 Kenworth T440, 2009-2015 Kenworth T660, 2015-2024 Kenworth T680, 2008-2024 Kenworth T800, 2009-2020 Kenworth T370, 2013-2023 Kenworth T880, 2011-2016 Kenworth T470, 2023 Kenworth T480, 2021-2023 Kenworth T800B, and 2009-2019 Kenworth W900 vehicles. The air tanks have an insufficient volume of air for the brake system. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard number 121, "Air Brake Systems."
Risk: Insufficient air volume can reduce braking performance and increase the risk of a crash.
2024 KENWORTH T480
10611 vehicles affected
VISIBILITY:REARVIEW MIRRORS/DEVICES
PACCAR Incorporated (PACCAR) is recalling certain 2022-2024 Peterbilt 535, 536, 537, 548, and Kenworth T180, T280, T380, T480 trucks. The glass lock ring on the cab mirror assembly may not be fully seated, allowing the mirror glass to detach.
Risk: A detached mirror glass can reduce driver visibility, increasing the risk of a crash.
2025 KENWORTH T480
45887 vehicles affected
STEERING
PACCAR Incorporated (PACCAR) is recalling certain 2024-2025 Kenworth T280, T380, T480, T680, T880, L770, W990, and 2024-2025 Peterbilt 389, 520, 535, 536, 537, 548, 567, 579, 589 trucks. The steering gear assemblies may have been assembled incorrectly with fewer recirculating balls than are required, which may result in a loss of steering control.
Risk: A loss of steering control increases the risk of a crash.
Recent Complaints
No recent complaints found.