2011 IC BUS FECB
View all complaints and recalls for this specific model year.
2011 IC BUS FECB Summary
2011
Model Year
0
Total Complaints
3
Total Recalls
156
Vehicles Affected
Recalls
2011 IC BUS FECB
68 vehicles affected
EQUIPMENT ADAPTIVE/MOBILITY
Navistar, Inc. is recalling certain model year 2007-2015 IC CE transit buses, 2008-2011 IC FE transit buses and 2009-2013 IC RE transit buses equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts by Ricon. The affected lifts are equipped with folding link arms that may have pivot holes that are too big, allowing the bearings to move out of position.
Risk: If the bearings move out of position, the stowed platform may have excessive movement resulting in failure of the platform mounting. This failure could cause the wheel chair lift platform to fall out of the vehicle when the doors are opened, increasing the risk of injury for the lift operator.
2011 IC BUS FECB
68 vehicles affected
EQUIPMENT ADAPTIVE/MOBILITY
Navistar, Inc.(Navistar) is recalling certain model year 2007-2015 IC CE transit buses manufactured January 23,2006, to May 12, 2014, 2008, and 2011 IC FE transit buses manufactured October 5, 2006, to September 28, 2009, and 2009-2010, and 2013 IC RE transit buses manufactured September 19, 2007, to November 29, 2011, equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair lifts manufactured by Ricon Corporation after January 1, 2006. The platform side plate of the affected wheelchair lifts may crack.
Risk: If the platform side plates crack, the lift platform can separate from the lift and come to rest against the vehicle's lift door. When the doors are opened, the platform may fall out, increasing the risk of injury to the lift operator.
2011 IC BUS FECB
20 vehicles affected
EQUIPMENT ADAPTIVE/MOBILITY
NAVISTAR IS RECALLING CERTAIN MODEL YEAR 2009 THROUGH 2011 IC CE, FE, RE, AND BE MODEL NON SCHOOL BUSES MANUFACTURED FROM DECEMBER 10, 2007 THROUGH JANUARY 12, 2010 AND FITTED WITH RICON PUBLIC USE LIFTS. THE RESTRAINT BELT ON THESE LIFTS WAS DESIGNED TO PREVENT THE LIFT FROM MOVING, UNLESS THE TONGUE OF THE BELT IS FULLY ENGAGED AND LATCHED IN THE BUCKLE. RICON HAS DISCOVERED, HOWEVER, THAT IT IS POSSIBLE FOR THE OPERATOR TO INSERT THE BELT TONGUE INTO THE BUCKLE WITHOUT FULLY ENGAGING THE LATCHING MECHANISM. IN THIS CASE, THE RESTRAINT BELT WOULD APPEAR TO BE LATCHED, AND THE OPERATOR COULD RUN THE LIFT. IF THE RESTRAINT BELT TONGUE IS NOT FULLY ENGAGED INTO THE RESTRAINT BELT BUCKLE, AND LATCHED, THE LIFT MAY OPERATE WITH AN OCCUPANT ON THE PLATFORM.
Risk: THE USER OF THE LIFT COULD BE INJURED SHOULD THE LIFT MOVE WITHOUT THE RESTRAINT BELT PROPERLY BUCKLED.
Complaints
No complaints found.