2015 HONDA FIT

AIR BAGS:SIDE/WINDOW

Honda (American Honda Motor Co.) is recalling certain model year 2015-2016 Fit LX-trim vehicles manufactured April 11, 2014, to July 02, 2015 and not equipped with a sunroof. In the affected vehicles, the rear grab handle brackets were not manufactured properly, and as a result, the brackets may puncture the side curtain air bags upon their deployment. As such, these vehicles fail to comply with Federal Motor Vehicle Safety Standard (FMVSS) number 214, "Side Impact Protection" and number 226, "Ejection Mitigation".

Risk: If the side curtain air bags are punctured upon deployment, the outboard seat occupants may be at a higher risk of injury during a crash.

POWER TRAIN:AUTOMATIC TRANSMISSION:CONTROL MODULE (TCM/PCM/TECM)

Honda (American Honda Motor Co.) is recalling certain model year 2014-2015 Civic vehicles manufactured January 16, 2014, to November 6, 2014 and 2015 Fit vehicles manufactured March 12, 2014, to May 12, 2015. The software settings that control the transmission operation may result in damage to the transmission drive pulley shaft.

Risk: If the transmission drive pulley shaft is damaged, it may break, and the vehicle may lose acceleration or the front wheels may lock up while driving, increasing the risk of a crash.

ELECTRICAL SYSTEM:IGNITION

Honda (American Honda Motor Co.) is recalling certain model year 2015 Fit vehicles manufactured December 6, 2013, to August 28, 2014. The affected vehicles may experience damage to the wires inside the Plug Top Ignition Coils (PTC) due to improper protection against electrical noise.

Risk: If the wires become damaged, the coil may overheat and cause the engine to stall, increasing the risk of a crash.

UNKNOWN OR OTHER

The fuel gauge, which is digital, has a soldering point which is apparently a known failure spot due to the type of solder used. This causes the display to fail, which makes the fuel gauge unreadable. Not only is this a distraction for drivers, but it can lead to running out of gas unexpectedly in dangerous situations.

UNKNOWN OR OTHER

The fuel gauge, which is digital, has a soldering point which is apparently a known failure spot due to the type of solder used. This causes the display to fail, which makes the fuel gauge unreadable. Not only is this a distraction for drivers, but it can lead to running out of gas unexpectedly in dangerous situations.

UNKNOWN OR OTHER

The fuel gauge, which is digital, has a soldering point which is apparently a known failure spot due to the type of solder used. This causes the display to fail, which makes the fuel gauge unreadable. Not only is this a distraction for drivers, but it can lead to running out of gas unexpectedly in dangerous situations.

UNKNOWN OR OTHER

The fuel gauge, which is digital, has a soldering point which is apparently a known failure spot due to the type of solder used. This causes the display to fail, which makes the fuel gauge unreadable. Not only is this a distraction for drivers, but it can lead to running out of gas unexpectedly in dangerous situations.

UNKNOWN OR OTHER

The fuel gauge, which is digital, has a soldering point which is apparently a known failure spot due to the type of solder used. This causes the display to fail, which makes the fuel gauge unreadable. Not only is this a distraction for drivers, but it can lead to running out of gas unexpectedly in dangerous situations.

ENGINE

I am the owner of a Honda Fit, and I am reporting a persistent and worsening issue that began during the winter of 2024. The vehicle produces a rattling noise during cold start-ups, which has become increasingly loud and frequent over time. This vehicle has only 89,646 miles, which is considered relatively low mileage for a modern engine to begin exhibiting such symptoms. This suggests that the issue is not due to normal wear and tear, but rather a premature mechanical defect. Based on my research and discussions with other Honda owners, this issue appears to be linked to a defective Variable Valve Timing Control (VTC) actuator, a problem that has been documented in other Honda models and addressed through Technical Service Bulletin 16-088. I am concerned that this is not merely a cosmetic or nuisance issue. The noise suggests a mechanical defect that could lead to premature engine wear or even total engine failure if left unaddressed. Given the number of similar complaints across various Honda models, I believe this may be a manufacturing defect that warrants further investigation. I respectfully request that Honda acknowledge this issue in the Honda Fit and take appropriate action, whether through a recall, extended warranty, or goodwill repair program. I am also submitting this report to the National Highway Traffic Safety Administration (NHTSA) for further review.

POWER TRAIN

The contact owns a 2015 Honda Fit. The contact stated that while operating the vehicle, the transmission warning light started flashing and the vehicle failed to properly accelerate. The vehicle was taken to the local AAMCO Transmission Service Center who diagnosed that the transmission drive pulley had failed and needed to be replaced. The vehicle was not repaired. The local dealer and manufacturer were notified of the failure, but no assistance was provided. The contact was informed that the VIN was not included in NHTSA Campaign Number: 15V574000 (POWER TRAIN). The contact stated that the vehicle had experienced the failure listed in the recall. The failure mileage was 79,852.

ELECTRICAL SYSTEM

Instrument cluster is failing. Requires replacement.

ENGINE

Vtc actuator failure. Engine rattle on cold startup.

ELECTRICAL SYSTEM

Many other Honda Fit owners and I have had the same problem of the odometer and fuel gauge not displaying correctly. The soldering pins crack or come loose over time. This leads to failure to tell if you have enough gas in the car. This also leads to failure to show an accurate odometer reading. The odometer and fuel gauge display is digital and the screen often will glitch out and display a jumble of letters and numbers. Sometimes the odometer and fuel gauge display nothing at all. In these cases, you simply have to hope you have enough gas to get to where you need to go. This is a critical safety issue as someone could run out of gas in the middle of fast highway traffic without knowing. This is also an odometer issue because the odometer can sometimes show the wrong number for the total amount of miles driven on the car.

ENGINE

My Honda Fit was purchased new in Portland, Oregon. I am the original owner. I began having issues that are documented after moving to Florida, and took the car to Honda in Palm Bay. The issues were grinding noise at the first start of the day, or after sitting for several hours and then restarted. The noise is noticed upon start in am or 1st start and is a grinding noise from the motor area. It sounds like a knock/grinding, like the motor is starting and has no oil in it. But the oil level is okay and it is not out of oil. This continues today, after being at the same dealer several times. The service department stated that they needed me to leave the car overnight to try to diagnose the issue after the car sat all night because the noise only comes after sitting all night or long periods. I left the car more than once at the dealership. The dealer in Palm Bay stated "they were unable to re-produce the knocking/grinding that has been occurring since about 11,000 miles. The car is still grinding or knocking and after taking to another dealer in Tampa, Fl I was told it was a DTC and they refused to fix it. It is now just over mileage under warranty, and was there for the grinding and a recall for the start stop switch which is now faulty again, or that wasn't the issue leaving me stranded. The car has several issues that are recall related that were supposed to be fixed and are nor. The plug coil tops The start stop run switch to start car- was replaced in 7/2022 and now I cant drive the car again.

ELECTRICAL SYSTEM

My Honda Fit was purchased new in Portland, Oregon. I am the original owner. I began having issues that are documented after moving to Florida, and took the car to Honda in Palm Bay. The issues were grinding noise at the first start of the day, or after sitting for several hours and then restarted. The noise is noticed upon start in am or 1st start and is a grinding noise from the motor area. It sounds like a knock/grinding, like the motor is starting and has no oil in it. But the oil level is okay and it is not out of oil. This continues today, after being at the same dealer several times. The service department stated that they needed me to leave the car overnight to try to diagnose the issue after the car sat all night because the noise only comes after sitting all night or long periods. I left the car more than once at the dealership. The dealer in Palm Bay stated "they were unable to re-produce the knocking/grinding that has been occurring since about 11,000 miles. The car is still grinding or knocking and after taking to another dealer in Tampa, Fl I was told it was a DTC and they refused to fix it. It is now just over mileage under warranty, and was there for the grinding and a recall for the start stop switch which is now faulty again, or that wasn't the issue leaving me stranded. The car has several issues that are recall related that were supposed to be fixed and are nor. The plug coil tops The start stop run switch to start car- was replaced in 7/2022 and now I cant drive the car again.