2023 GMC ACADIA

VISIBILITY:WINDSHIELD

General Motors, LLC (GM) is recalling certain 2023 GMC Acadia and 2024 Cadilac XT5 and XT6 vehicles. The windshield may have been assembled without the proper urethane sealant required to bond the windshield to the vehicle body.

Risk: A windshield that is not properly bonded may detach during a crash and increase the risk of injury.

POWER TRAIN:AUTOMATIC TRANSMISSION

General Motors, LLC (GM) is recalling certain 2023 Cadillac XT6, GMC Acadia, Chevrolet Blazer, Traverse, and 2022-2023 Cadillac XT5 vehicles. The transmission may have been built with an incorrect sun gear, which can result in the driver-side half-shaft disengaging from the transmission.

Risk: A half-shaft disengaging from the transmission can result in a loss of drive power or vehicle rollaway when the vehicle is placed in park. Either of these scenarios can increase the risk of a crash.

POWER TRAIN:DRIVELINE:DRIVESHAFT

General Motors, LLC (GM) is recalling certain 2023 Cadillac XT5 and GMC Acadia vehicles. The right-front half-shaft assemblies may be improperly connected to the transmission, causing them to separate.

Risk: Separation between the half-shaft and transmission can result in a loss of drive power or vehicle rollaway when the vehicle is placed in park. Either of these scenarios can increase the risk of a crash.

FORWARD COLLISION AVOIDANCE: AUTOMATIC EMERGENCY BRAKING

While driving under normal conditions, the vehicle experienced a sudden, violent deceleration. The emergency braking and collision avoidance systems activated spontaneously, as if the vehicle had struck or was about to strike an object. There was no obstacle, impact, or external threat present. This uncommanded braking caused significant physical stress and injury to the occupants. Critically, multiple safety systems failed during the event: The seat belts did not lock, failing to restrain the occupants; The airbags did not deploy, despite the severity of the deceleration; no warning indicators or diagnostic alerts were present before or after the incident. These failures directly contributed to physical injuries, including TBI (concussion, spinal trauma, etc.) which required emergency medical treatment and ongoing care.

SEAT BELTS

While driving under normal conditions, the vehicle experienced a sudden, violent deceleration. The emergency braking and collision avoidance systems activated spontaneously, as if the vehicle had struck or was about to strike an object. There was no obstacle, impact, or external threat present. This uncommanded braking caused significant physical stress and injury to the occupants. Critically, multiple safety systems failed during the event: The seat belts did not lock, failing to restrain the occupants; The airbags did not deploy, despite the severity of the deceleration; no warning indicators or diagnostic alerts were present before or after the incident. These failures directly contributed to physical injuries, including TBI (concussion, spinal trauma, etc.) which required emergency medical treatment and ongoing care.

SERVICE BRAKES

While driving under normal conditions, the vehicle experienced a sudden, violent deceleration. The emergency braking and collision avoidance systems activated spontaneously, as if the vehicle had struck or was about to strike an object. There was no obstacle, impact, or external threat present. This uncommanded braking caused significant physical stress and injury to the occupants. Critically, multiple safety systems failed during the event: The seat belts did not lock, failing to restrain the occupants; The airbags did not deploy, despite the severity of the deceleration; no warning indicators or diagnostic alerts were present before or after the incident. These failures directly contributed to physical injuries, including TBI (concussion, spinal trauma, etc.) which required emergency medical treatment and ongoing care.

SERVICE BRAKES, HYDRAULIC:FOUNDATION COMPONENTS:DISC:CALIPER

The contact owns a 2023 GMC Acadia. The contact stated while driving 55 MPH, while attempting to depress the brake pedal, the contact heard an abnormal sound coming from the brakes. A dealer and independent mechanic were contacted. No warning light was illuminated. The vehicle was taken to an independent mechanic to be diagnosed, and the contact was informed that the brake pads wear was uneven on the driver’s side and the driver’s side front caliper needed to be replaced. The vehicle was then taken to the dealer where it was diagnosed; however, the result was not provided. The brake pads were replaced; however, the caliper was not yet replaced. The manufacturer was notified of the failure, and informed the contact to take the vehicle to the dealer for assistance. The approximate failure mileage was 39,000.

STRUCTURE

The contact owns a 2023 GMC Acadia. The contact stated that after purchasing the vehicle, it was discovered that there was water and condensation inside the rear middle brake light assembly. The contact later discovered that during rainstorms, rainwater had leaked into the rear seating and hatch area of the vehicle. The vehicle was taken to the local dealer who determined that the failure was due to a manufacturing structural error and the vehicle needed body work to be performed to correct the failure. The vehicle was not yet repaired. The manufacturer was notified of the failure. The failure mileage was 5,200.

ENGINE

I've had the engine stall before coming to a complete stop on several occasions. It also has been shifting hard and has had a delayed shift. The other day all of the lights to to screen and speedometer completely went out while driving then randomly came back on. That's the only speedometer I have is the digital screen.

ELECTRICAL SYSTEM

Backup camera failed. Same issue on 2021 Acadia SLT Needs to be investigated on 2023 models

TIRES

See attached document for complaint.

STEERING

See attached document for complaint.

ENGINE

I am experiencing a recurring P04FB diagnostic trouble code on my 2023 GMC Acadia, related to the crankcase pressure sensor. GM issued Bulletin No. PIP5841C, which attributes the issue to moisture buildup freezing inside the sensor. Their recommended fix is to remove the sensor, blow out any moisture, and reinstall it. However, this is not a permanent solution—the code returns within days, suggesting an inherent design flaw in the PCV system. Additionally, the replacement sensor (Part #12718935) is on national backorder, making it impossible to obtain. Many owners across multiple GM models using this engine (such as the Chevrolet Blazer and Cadillac XT4) are experiencing the same problem, yet GM has not provided a real solution. A properly designed PCV system should not allow excessive moisture to accumulate in the sensor. Instead of addressing the root cause, GM’s bulletin merely delays the issue by temporarily clearing the moisture. This approach does not prevent the problem from recurring, and it does not fix the underlying defect. If the sensor fails or provides inaccurate readings, it can affect emissions and engine performance. The fact that the replacement part is unavailable suggests GM may be restricting access to it, possibly because they know it is defective. This raises concerns that GM is quietly managing a widespread issue rather than issuing a formal recall or warranty extension. I am requesting that the NHTSA investigate this issue, as GM's current approach does not resolve the problem. Owners should not be forced to repeatedly clear moisture from a sensor that is failing due to a design flaw. If GM has internally identified a better solution, it should be made available to affected owners instead of delaying action with ineffective temporary fixes.

FUEL/PROPULSION SYSTEM

I am experiencing a recurring P04FB diagnostic trouble code on my 2023 GMC Acadia, related to the crankcase pressure sensor. GM issued Bulletin No. PIP5841C, which attributes the issue to moisture buildup freezing inside the sensor. Their recommended fix is to remove the sensor, blow out any moisture, and reinstall it. However, this is not a permanent solution—the code returns within days, suggesting an inherent design flaw in the PCV system. Additionally, the replacement sensor (Part #12718935) is on national backorder, making it impossible to obtain. Many owners across multiple GM models using this engine (such as the Chevrolet Blazer and Cadillac XT4) are experiencing the same problem, yet GM has not provided a real solution. A properly designed PCV system should not allow excessive moisture to accumulate in the sensor. Instead of addressing the root cause, GM’s bulletin merely delays the issue by temporarily clearing the moisture. This approach does not prevent the problem from recurring, and it does not fix the underlying defect. If the sensor fails or provides inaccurate readings, it can affect emissions and engine performance. The fact that the replacement part is unavailable suggests GM may be restricting access to it, possibly because they know it is defective. This raises concerns that GM is quietly managing a widespread issue rather than issuing a formal recall or warranty extension. I am requesting that the NHTSA investigate this issue, as GM's current approach does not resolve the problem. Owners should not be forced to repeatedly clear moisture from a sensor that is failing due to a design flaw. If GM has internally identified a better solution, it should be made available to affected owners instead of delaying action with ineffective temporary fixes.