COLLINS BANTAM
View complaints and recalls by year, or see all recent reports below.
COLLINS BANTAM Summary
10
Model Years
0
Total Complaints
17
Total Recalls
2002 - 2011
Year Range
Select Year
Recent Recalls
2010 COLLINS BANTAM
251 vehicles affected
ELECTRICAL SYSTEM
Collins Bus Corporation (Collins) is recalling certain model year 2009-2010 Bantam, Super Bantam, Grand Bantam, Mid Bus Guide, Super Guide, and Grand Guide school buses manufactured September 2009 through April 2010, and equipped with A&M Systems-brand electric door actuators. Voltage spikes may damage electrical components and electrical circuits, causing the circuit board to develop high resistance.
Risk: High resistance may cause the board to overheat, increasing the risk of a fire.
2006 COLLINS BANTAM
11 vehicles affected
EQUIPMENT:APPLIANCE:AIR CONDITIONER
COLLINS IS RECALLING CERTAIN MODEL YEAR 2006 THROUGH 2008 BANTAM, GRAND BANTAM, AND SUPER BANTAM SCHOOL BUSES MANUFACTURED FROM AUGUST 23, 2006, THROUGH FEBRUARY 1, 2008, EQUIPPED WITH CARRIER GENV EM-1 EVAPORATOR UNITS. DUE TO TIME, TEMPERATURE, AND/OR VIBRATION, THE FUSE MAY LOOSEN IN THE FUSE HOLDER RESULTING IN HIGH RESISTANCE AND ARCING.
Risk: IF SUFFICIENT ARCING OCCURS, THE FUSE HOLDER MAY MELT, AND A VEHICLE FIRE MAY OCCUR.
2002 COLLINS BANTAM
702 vehicles affected
SEATS
COLLINS IS RECALLING CERTAIN MODEL YEAR 2002-2011 BANTAM, GRAND BANTAM, AND SUPER BANTAM SCHOOL BUSES MANUFACTURED FROM OCTOBER 2002 THROUGH MAY 20, 2011, FOR FAILING TO CONFORM TO THE LEG PROTECTION ZONE IMPACT REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD 222 "SCHOOL BUS PASSENGER SEATING AND CRASH PROTECTION."
Risk: IN THE EVENT OF A VEHICLE CRASH, THE VEHICLE OCCUPANTS MAY NOT BE ADEQUATELY PROTECTED AND MAY SUSTAIN INJURIES.
2009 COLLINS BANTAM
112 vehicles affected
EXTERIOR LIGHTING:BRAKE LIGHTS
COLLINS IS RECALLING CERTAIN MODEL YEAR 2009 BANTAM, SUPER BANTAM, AND GRAND BANTAM SCHOOL BUSES MANUFACTURED BETWEEN APRIL 1 AND OCTOBER 1, 2009, BUILT ON FORD CUTAWAY CHASSIS. THE BRAKE-TURN SEPARATOR MODULE WHICH IS USED TO CONTROL THE BRAKE LIGHTS AND TURN SIGNALS LIGHTS IN THE REAR MAY NOT ALWAYS DISTINGUISH CORRECTLY BETWEEN A BRAKE SIGNAL INPUT AND A TURN SIGNAL INPUT FROM THE FORD CHASSIS OEM WIRING. FOR TYPICAL BRAKE AND TURN SIGNAL OPERATION, THE STOP/TAIL/TURN LIGHTS AT THE REAR OF THE BUS WILL FUNCTION PROPERLY. HOWEVER, IF THE BRAKES ARE PUMPED/APPLIED IN A FREQUENCY MATCHING THAT OF THE BLINKING TURN SIGNAL WHILE THE TURN INDICATOR IS ON, THERE IS THE POTENTIAL THAT THE BRAKE SIGNAL THROUGH THE MODULE MAY CANCEL OUT THE TURN SIGNAL TEMPORARILY OR CAUSE IT TO FLASH INTERMITTENTLY.
Risk: THIS CAN CAUSE CONFUSION TO VEHICLES BEHIND THE BUS AS TO WHETHER THE BUS IS TURNING OR STOPPING INCREASING THE RISK OF A CRASH.
2008 COLLINS BANTAM
516 vehicles affected
SEATS
COLLINS IS RECALLING CERTAIN MODEL YEAR 2008 BANTAM, GRAND BANTAM, AND SUPER BANTAM MODEL SCHOOL BUSES. THE 39 INCH THREE PASSENGER SEATS FAIL TO MEET THE MINIMUM PERFORMANCE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NO. 222, "SCHOOL BUS PASSENGER AND CRASH PROTECTION."
Risk: SEAT OCCUPANTS ARE AT AN INCREASED RISK OF INJURY IN THE EVENT OF A CRASH.
Recent Complaints
No recent complaints found.