2008 CHEVROLET HHR
View all complaints and recalls for this specific model year.
2008 CHEVROLET HHR Summary
2008
Model Year
2
Total Complaints
3
Total Recalls
4396477
Vehicles Affected
Recalls
2008 CHEVROLET HHR
2190934 vehicles affected
ELECTRICAL SYSTEM:IGNITION:SWITCH
This defect can affect the safe operation of the airbag system. Until this recall is performed, customers should remove all items from their key rings, leaving only the ignition key. The key fob (if applicable), should also be removed from the key ring. General Motors LLC (GM) notified the agency on February 10, 2014 that they are recalling 619,122 model year 2005-2007 Chevrolet Cobalt, and 2007 Pontiac G5 vehicles. On February 25, 2014, GM increased the recall to include an additional 748,024 model year 2006-2007 Chevrolet HHR and Pontiac Solstice vehicles and 2003-2007 Saturn Ion vehicles and 2007 Saturn Sky vehicles. In these models, the weight on the key ring and/or road conditions or some other jarring event may cause the ignition switch to move out of the run position, turning off the engine. On March 27, 2014, GM notified the agency that the defective ignition switches may have been used as service replacement parts on other vehicles, and as a result GM will be recalling certain model year 2008-2010 Chevrolet Cobalt, Saturn Sky, and Pontiac G5 and Solstice, and 2008-2011 Chevrolet HHR vehicles. The part numbers for the service parts are 10392423 (a/k/a ACDelco D1461F), 10392737, 15857948, 15854953, 15896640, and 25846762. This expansion represents an additional 823,788 vehicles.
Risk: If the key is not in the run position, the air bags may not deploy if the vehicle is involved in a crash, increasing the risk of injury.
2008 CHEVROLET HHR
2191014 vehicles affected
ELECTRICAL SYSTEM:IGNITION
General Motors LLC (GM) is recalling certain model year 2005-2010 Chevrolet Cobalt, 2006-2011 Chevrolet HHR, 2007-2010 Pontiac G5, 2006-2010 Pontiac Solstice, 2003-2007 Saturn Ion, and 2007-2010 Saturn Sky vehicles. In the affected vehicles, the key can be removed from the ignition when the ignition is not in the "Off" position.
Risk: If the key can be removed from the ignition when the ignition is not in the "off" position, the vehicle could roll away: (a) for an automatic transmission, if the transmission is not in the "Park" position; or (b) for a manual transmission, if the parking brake is not engaged and the transmission is not in the "Reverse" position. This potential for rollaway increases the risk for a crash and occupant or pedestrian injuries.
2008 CHEVROLET HHR
14529 vehicles affected
ELECTRICAL SYSTEM:IGNITION:SWITCH
UCI-FRAM Group is recalling certain LS1328 ignition Switches sold as Wells LS1328, Duralast LS1328, Airtex 1S6097, and Carquest 53-27479, and LS1497 Ignition Switches sold as Wells LS1497, Duralast LS1497, Airtex 1S10961, and Carquest 53-27967, for use on various General Motors model and model year vehicles during repair and replacement of the original ignition switch. The weight on the key ring and/or road conditions or some other jarring event may cause the affected ignition switches to move out of the run position, turning off the engine and disabling the air bags.
Risk: If the ignition switch moves from the run position to accessory, the car would stall and the air bags will not deploy in the event of a crash, increasing the risk of personal injury to the occupants.
Complaints
2008 CHEVROLET HHR
ID: 2079394VISIBILITY:GLASS, SIDE/REAR
The contact owns a 2008 Chevrolet HHR. The contact stated while warming up the vehicle, the rear window exploded without warning or impact. There was smoke coming from the front of the vehicle. There was an abnormal burning odor detected. The contact called the local dealer, but the vehicle was not diagnosed or repaired. The manufacturer was not made aware of the failure. The failure mileage was approximately 56,000. The VIN was not available.
2008 CHEVROLET HHR
ID: 2062992VEHICLE SPEED CONTROL
vehicle ecm keeps reporting an error code p2138 that refers to a correlation issue between sensors on the throttle/pedal system, causing the vehicle to enter into reduced power and eventually disables engine. Problem persists even after replacing pedal component. Apparently water enters the compartment where the part is located and corrodes wiring between the ecm and the pedal system. GM is apparently aware but so far has done nothing. Problem is especially hazardous because engine power is reduced during acceleration and happens without warning. Vehicle could be in high density traffic and then suddenly experiences lack of power or total disability, and driver must try to navigate to the side of the road--not always possible or safe to do.