2012 ALTEC DIGGER DERRICK Complaints and Recall Information
The 2012 ALTEC DIGGER DERRICK has 0 complaints and 11 recalls filed with NHTSA. Owners frequently report issues related to equipment defects and electrical system problems as identified in recall actions.
There are 11 recalls affecting various systems including equipment components such as digger extension shafts, winch drums, and brackets, as well as electrical wiring and battery systems. These recalls address mechanical failures and potential fire hazards affecting safety.
Recalls- Extension shaft defect. NHTSA recall 12V423000 affects 2,193 vehicles due to a stress fracture risk at a weld joint on the PENGO digger extension shaft. Failure may cause the shaft to separate, risking injury or damage. Altec inspects and replaces the shaft as needed at no cost.
- Winch drum failure. Recall 13V141000 involves 1,057 vehicles with Tulsa Winch Group drums that may deform or fracture, risking injury if the winch fails. The drums are replaced free of charge by dealers.
- Feeder tube bracket loose. Recall 13V636000 concerns 661 vehicles where fasteners on the feeder tube bracket may loosen, causing the tube to fall and risk injury. Owners receive upgraded bracket installations free of charge.
- Winch motor bolts loose. Recall 13V390000 covers 1,743 vehicles with bolts on the winch motor that may be insufficiently tightened, risking detachment and load drops. Service personnel check and correct bolt torque without charge.
- Battery equalizer fire risk. Recall 14V503000 affects 51 vehicles with Sure Power Battery Equalizers containing a potting compound that can conduct electricity when hot, potentially causing fires. Dealers replace affected units free of charge.
- Hydraulic load valve error. Recall 23V636000 for 53 vehicles covers incorrectly installed hydraulic load holding valves that may cause uncontrolled lowering and load drops. Altec replaces valves free of charge.
- Incorrect slope placards. Recall 19V365000 involves 1,036 vehicles with slope indicator cards that may falsely indicate safe operation without leveling on a 5-degree slope, risking instability. Altec issues removal instructions and replacements at no cost.
- Wiring and circuit breaker issues. Recall 18V791000 for 331 vehicles addresses undersized wiring from chassis battery to Power Distribution Module causing overheating and fire risk. Dealers replace wiring and/or breakers free of charge.
- Pedestal tube weld cracks. Recall 19V127000 covers 14,389 vehicles with pedestal welds that may crack, risking failure and uncontrolled movement. Altec provides repairs and reinforcing kits free of charge.
- Trailer relay module breaker defect. Recall 15V101000 affects 5,142 vehicles with slow-acting 30 amp breakers that may allow overheating and fire risk. Dealers replace breakers with 20 amp units at no cost.
Owners with repeated repairs, unresolved recall issues, or safety concerns related to this model may have rights under their state’s lemon law. They should consider consulting legal assistance to explore their options.
2012 ALTEC DIGGER DERRICK Summary
2012
Model Year
0
Total Complaints
10
Total Recalls
26656
Vehicles Affected
Recalls
2012 ALTEC DIGGER DERRICK
53 vehicles affected
EQUIPMENT:MECHANICAL:WINCH
Altec Industries, Inc. (Altec) is recalling certain 2004-2023 DL42 and DL45 Digger Derricks. The incorrect hydraulic load holding valve may have been installed, which can cause the winch to lower uncontrollably and the load to fall.
Risk: An uncontrolled load falling increases the risk of injury to personnel or others nearby.
2012 ALTEC DIGGER DERRICK
1036 vehicles affected
EQUIPMENT:OTHER:LABELS
Altec Industries Inc. (Altec) is recalling certain 2009-2019 DL/DM, DL/DMB, DH, D/2/3/4, and DC Digger Derrick vehicles. The slope indicator placard card may falsely indicate that the unit could be used without leveling on a 5 degree slope.
Risk: An operator may improperly set up the unit, making the unit unstable, thus increasing the risk of injury.
2012 ALTEC DIGGER DERRICK
14389 vehicles affected
EQUIPMENT
Altec Industries, Inc (Altec) is recalling certain 2003-2019 Altec DL/DM, DL/DMB, and DC Digger Derrick vehicles. The pedestal tube welds may crack over time.
Risk: Unrepaired cracks may result in failure of the pedestal and uncontrolled movement increasing the risk of injury.
2012 ALTEC DIGGER DERRICK
331 vehicles affected
ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES
Altec Industries, Inc. (Altec) is recalling certain 2008-2018 Altec AC18, AC23, AC26, AC30 and AC38 Cranes and D2B, D3A, D4A/B, DL42B, DT65 and DT80 Digger Derrick vehicles. The wiring on the 12V circuit from the chassis battery to the Power Distribution Module (PDM) may be insufficiently sized.
Risk: The insufficiently sized wire may overheat, increasing the risk of fire.
2012 ALTEC DIGGER DERRICK
5142 vehicles affected
ELECTRICAL SYSTEM
Altec Industries Inc. (Altec) is recalling certain model year 2012-2014 Digger Derrick and Aerial Device vehicles manufactured October 1, 2012, to June 30, 2014, and mounted on Freightliner chassis. In the event of a short circuit condition, the 30 amp breaker to the trailer relay module may react too slowly to prevent the module from overheating.
Risk: If the module overheats, there is an increased risk of a fire.
2012 ALTEC DIGGER DERRICK
51 vehicles affected
ELECTRICAL SYSTEM:12V/24V/48V BATTERY
Altec Industries, Inc. (Altec) is recalling certain model year 2000-2013 Aerial Device and Digger Derrick trucks, equipped with Sure Power Battery Equalizers containing a particular epoxy sealing, aka 'potting', compound. The specific potting compound used in the subject products for insulation was found to be capable of conducting electricity after being exposed to heat.
Risk: Once electrically conductive, the material is capable of melting and burning, increasing the risk of a fire.
2012 ALTEC DIGGER DERRICK
1743 vehicles affected
EQUIPMENT
Altec is recalling certain model year 2012-2013 Digger Derrick models D2/3/4 and DC/DL/DM manufactured June 2012 through July 2013. The bolts that attach the winch motor to the winch may not be properly tightened and may become loose.
Risk: If the bolts come loose, the winch motor may detach causing the load to fall, which may result in personal injury.
2012 ALTEC DIGGER DERRICK
661 vehicles affected
EQUIPMENT
Altec Industries Inc. (Altec) is recalling certain model year 2009-2013 DT80, and model year 2011-2013 D2, D3 and D4 digger derrick models manufactured June 2009 through November 2013. The fasteners that hold the bracket for the feeder tube (the telescopic hydraulic tube that supplies pump flow to the auger) may become loose allowing the feeder tube to fall.
Risk: A falling feeder tube increases the risk of injury to people nearby.
2012 ALTEC DIGGER DERRICK
1057 vehicles affected
EQUIPMENT
Altec Industries, Inc (Altec) is recalling certain model year 2007-2012 DC, and DL/DM Digger Derrick utility trucks, equipped with boom tip winches using Tulsa Winch Group (formerly Gear Products) winch drums. In the affected vehicles, the winch drum could deform or fracture.
Risk: If the winch fails while in use, it could cause personal injury.
2012 ALTEC DIGGER DERRICK
2193 vehicles affected
EQUIPMENT
Altec Industries, Inc. is recalling certain model year 2011-2012 Digger Derrick vehicles equipped with a PENGO digger extension shaft. A defect in the base material at the weld joint may result in a stress fracture through the applied weld of the drive hub to the hex bar material.
Risk: The stress fracture could cause the extension shaft to separate from the drive hub when digging, increasing the risk of personal injury and/or property damage.
Complaints
No complaints found.