ALTEC AT200A
View complaints and recalls by year, or see all recent reports below.
ALTEC AT200A Summary
15
Model Years
0
Total Complaints
23
Total Recalls
2006 - 2024
Year Range
Select Year
Recent Recalls
2024 ALTEC AT200A
82 vehicles affected
SUSPENSION:FRONT:SPRINGS:COIL SPRINGS
Altec Industries, Inc. (Altec) is recalling certain 2017-2024 Ford E350 van chassis equipped with a AT200A devices. The units mounted on certain Ford E350 van chassis with Gross Axle Weight Rating (GAWR) of 4050 and 4200 pounds, may fail at high loads due to a defect in the front axle.
Risk: Overload of the front axle capacity could cause it to fail and instability, increasing the risk of injury.
2016 ALTEC AT200A
16 vehicles affected
TIRES:MARKINGS
Altec Industries Inc. (Altec) is recalling certain 2016-2018 AT200A vehicles built on Ford E-350 Cutaway chassis. The rear tire size and load rating may be incorrect, possibly resulting in the vehicle being overloaded.
Risk: An overload condition may reduce the vehicle's stability or result in tire failure, increasing the risk of a crash.
2010 ALTEC AT200A
761 vehicles affected
ELECTRICAL SYSTEM:12V/24V/48V BATTERY:CABLES
Altec Industries, Inc. is recalling certain model year 2010-2012 AT200A, AT235/235P, AT237, AT248F, AT35/37-G, and AT40-G aerial devices built on Ford F550 chassis with a gross vehicle weight rating of 19,500lbs. The battery cable going to the unit auxiliary functions could be damaged and possibly short to ground.
Risk: If the battery cable shorts to ground, it may overheat, resulting in a fire.
2011 ALTEC AT200A
1145 vehicles affected
ENGINE AND ENGINE COOLING:EXHAUST SYSTEM
Altec Industries, Inc. (Altec) is recalling certain model year 2010-2013 AT200A, AT235, AT235P, AT30-G, AT35-G, AT37-G, AT40-G and AT237 Aerial Devices mounted on Ford Super Duty Chassis' equipped with 6.8L gas engines and Muncie FR67 power take offs (PTO). In the affected vehicles, oil may leak from the PTO pressure switch onto a thermal blanket covering the exhaust.
Risk: Oil leaking onto the thermal blanket combined with heat from exhaust may result in an increased risk of fire.
2012 ALTEC AT200A
141 vehicles affected
SUSPENSION:FRONT:SPRINGS:TORSION BAR
Altec Industries, Inc. is recalling certain model year 2012 Aerial Device vehicles built on a Navistar Terrastar chassis because the Altec-installed torsion bar increases the ride height of the front suspension, which when the vehicle hits bumps, may cause the vehicle to alter its steering direction.
Risk: As the vehicle hits bumps, it may deviate from the intended line of travel, increasing the risk of a crash.
2007 ALTEC AT200A
832 vehicles affected
EQUIPMENT
ALTEC IS RECALLING CERTAIN AT35-G, AT37-G, AT235, AND AT237 AERIAL DEVICES MANUFACTURED FROM JANUARY 2005 THROUGH OCTOBER 2008. THESE UNITS ARE EQUIPPED WITH BILLET STEEL COUNTERWEIGHT THAT IS WELDED IN PLACE. IN THE EVENT OF WELD FAILURE, THE COUNTERWEIGHT MAY FALL OUT WHILE TRAVELLING.
Risk: IF THESE STEEL PIECES FALL IN THE PATH OF THE VEHICLE OR OTHER TRAFFIC, A VEHICLE CRASH INVOLVING DEATH OR SERIOUS INJURY MAY RESULT.
2007 ALTEC AT200A
34 vehicles affected
STEERING:HYDRAULIC POWER ASSIST:HOSE, PIPING, AND CONNECTIONS
ALTEC IS RECALLING CERTAIN MODEL YEAR 2006-2007 AT200A, AT235, MODEL YEAR 2007-2010 AT235P AND MODEL YEAR 2008 AT3XG TRUCKS BUILT ON GM CHASSIS. THERE IS A POTENTIAL HYDRAULIC HOSE ROUTING CONDITION IN THE ENGINE COMPARTMENT. THE HOSE COULD CONTACT AND CAUSE SOME ABRASIONS TO AN OEM 12V CHASSIS WIRE OR POSSIBLY RUB ON THE STEEL POWER STEERING LINE WHICH MAY LEAD TO POSSIBLE DAMAGE OF THE HYDRAULIC LINE.
Risk: THIS COULD RESULT IN A BURST HYDRAULIC HOSE DAMAGE WIRING, OR A FIRE.
Recent Complaints
No recent complaints found.